请百度搜索通达挖掘机维修关键词找到我们!

卡特故障代码

卡特330C挖掘机故障代码中英对照表

文字:[大][中][小] 手机页面二维码 2018/8/11     浏览次数:    
Engine Control发动机控制器(MID No.036)挖掘机维修,挖掘机修理,维修挖掘机,修理挖掘机|CIDComponent元件
0001        Injector Solenoid 1st Cylinder1#缸喷油器电磁阀
0002        Injector Solenoid 2nd Cylinder2#缸喷油器电磁阀
0003        Injector Solenoid 3rd Cylinder3#缸喷油器电磁阀
0004        Injector Solenoid 4th Cylinder4#缸喷油器电磁阀
0005        Injector Solenoid 5th Cylinder5#缸喷油器电磁阀
0006        Injector Solenoid 6th Cylinder6#缸喷油器电磁阀
0041        8V DC Supply 8V直流电源
0042        Injection Actuation Control Valve喷油器促动控制阀
0091        Throttle Position Signal油门位置信号
0094        Fuel Pressure Sensor燃油压力国传感器
0100        Engine Oil Pressure Sensor发动机机油压力传感器
0110        Engine Coolant Temperature Sensor发动机冷却液温度传感器
0164        Injector Actuation Pressure喷油器促动压力
0168        System Voltage 系统电压
0172        Intake Manifold Air Temperature进气岐管空气温度
0175        Engine Oil Temperature Sensor发动机机油温度传感器
0190        Engine Speed Sensor发动机速度传感器
0253        Personality Module 个性模块
0261        Engine Timing Calibration发动机正时校验
0262        5V Sensor DC Power Supply5V传感器直流电源
0268        Check Programable Parameters检查可编程参数
0273        Turbo Outlet Pressure Sensor涡轮增压器出口压力传感器
0274        Atmospheric Pressure Sensor大气压力传感器
0286        Oil Lamp机油灯
0342        Secondary Engine Speed Sensor次级发动机速度传感器
0617        Air Inlet Heater Relay空气进气加热继电器
1627        Fuel Pump Relay燃油泵继电器Engine / Pump Control发动机/泵控制器(MID No. 105)CID        Component元件
0091        Throttle Position Signal油门位置信号
0096        Fuel Level Sensor燃油油位传感器
0110        Engine Coolant Temperature Sensor发动机冷却液温度传感器
0167        Alternator发电机
0168        Voltage Of The Power Supply (Keyswitch) 钥匙门电压
0190        Speed Sensor速度传感器
0248        Cat Data LinkCAT数据线
0286        Signal For Low Engine Oil Pressure发动机机油压力低信号
0374        Swing Brake Solenoid回转制动电磁阀
0376        Travel Alarm 行走警报
0581        "Proportional Reducing Valve For The Powershift Pressure"动力换档比例减压阀
0586        Engine Speed Dial发动机速度盘式开关
0587        Feedback Sensor For The Governor Actuator调节器传动装置反馈信号
0590        Engine Controller发动机控制器
0598        Travel Speed Solenoid行走速度电磁阀
0600        Hydraulic Oil Temperature Sensor液压油温传感器
1161        Pump Delivery Pressure泵压
1162        Pump Delivery Pressure泵压
1524        "Proportional Solenoid Valve ForNegative Flow Control"负流量控制比例电磁阀1525Straight Travel Solenoid直线行走电磁阀1590"Proportional Solenoid Valve ForNegative Flow Control" 负流量控制比例电磁阀2002Action Alarm警报FMI故障描述       
0        Data valid but above normal operationl range数据正确,但高于正常范围
1        Data valid but below normal operationl range数据正确,但低于正常范围
2        Data erratic,intermittent ,or incorrect数据不稳,断续或不正确
3        Voltage above normal or shorted high电压高于正常或突然高
4        Voltage below normal or shorted low电压低于正常或突然低
5        Current below normal or open circuit电流低于正常或开路
6        Current above normal or grounded circuit电流高于正常或短路
7        Mechanical system not responding properly机器系统没有正确反应
8        Abnormal frequency, pulse width, or period.异常频率、脉冲或周期
9        Abnormal update.异常更新
10        Abnormal rate of change.异常变化率
11        Failure mode not identifiable.故障模式不能确认
12        Bad device or component.坏的设备或元件
13        Out of calibration.超出校验范围
14-31      Reserved保留事件代码Event Codes事件代码Engine / Pump Control发动机/泵控制器Event Code Condition       
017        Coolant Overheat冷却液高温
043        "Abnormal Battery Charge(Voltage To Power Supply Low)" 电压异常(电压低)
050        "Abnormal Battery Charge(Voltage To Power Supply High)" 电压异常(电压高)
059        Insufficient Level Of Coolant冷却液不足
095        Fuel Filter Is Clogged燃油滤芯堵塞
100        Engine Oil Pressure Is Low发动机机油压力低
119        Fuel Level Is Low燃油油位低
171        Engine Oil Level Is Low发动机机油油位低
179        "Abnormal Battery Charge(Charging Is Abnormal)" 电瓶充电异常
232        Water Separator Draining Demand油水分离器需排水
235        Hydraulic Oil Level Is Low液压油位低
236        Hydraulic Oil Filter Is Clogged液压油滤芯堵塞
237        Overload Warning过载警报
272        Air Filter Is Clogged空气滤芯堵塞
600        Hydraulic Oil Overheat液压油高温
862        Special Filter Is Clogged专用滤芯堵塞
863        Automatic Greasing Failure油脂自动注油失败Event Codes事件代码Engine Control发动机控制器Event CodeCondition       
005        Fuel Filter Restriction Derate燃油滤芯堵塞减额
015        High Engine Coolant Temperature Derate冷却液高温减额
017        High Engine Coolant Temperature Warning冷却液高温警报
025        High Inlet Air Temperature Derate进气温度高减额
027        High Inlet Air Temperature Warning进气温度高警报
039        Low Engine Oil Pressure Derate机油压力低减额
096        High Fuel Pressure燃油压力高
100        Low Engine Oil Pressure Warning发动机机油压力低警报
190        Engine Overspeed Warning发动机超速警报
265        User Defined Shutdown用户自定义熄火挖掘机技术故障与师傅进行沟通交流,官方网站http://www.yajcwx.com修理直拨:0551-64493367  服务专线:13956953738

返回上一步
打印此页
[向上]